Dji S?1000 Manuale Utente Scaricare il pdf (Pagina 20)

(2) When powering on the system, if the transmitter switch is in the [Raise] position, the LED will flash red

quickly as a warning. Toggle the switch to the [Lower] position to continue.

(3) If there is an abnormal signal or no signal input into the [IN] port, the LED will slowly flash red. Check

receiver and connections for problems.

(4) If servo power consumption is too high, the LED will light up red. If this lasts more than 4 seconds,

landing gear will lower and the LED will flash green slowly. Re-calibration is needed before flying.

(5) A2 flight control system users can use the A2 Assistant Software to set intelligent gear on the

“Advanced” page. Refer to the “A2 flight control system user manual” for details.

LED Control Board Indicator

System normal

Calibration required

Recalibration required

Calibration failed

Enter calibration mode

System calibrating

Motor stalled

Unsafe startup alert

Input signal abnormal

Specifications

Parameter

Range

Parameter

Range

Working Voltage

3S~6S (LiPo)

Input Signal

PWM (High-Pulse Width 800us~2200us)

Working Current

Max 1A@6S

Output Signal

PWM(Mid Position is 1520us) in 90Hz

Working Temperature

-20~70

Output Voltage

Total Weight

875g

Servo Travel

150

(Minimum120

)

1 2 ... 15 16 17 18 19 20 21 22 23 24 25 ... 31 32

Nessun commento

Dji S?1000 Manuale Utente Pagina 20